Scratching the paint on the exterior of a car can greatly affect its appearance, so many car owners will take the car to a 4S store for repainting at once. However, how can car repainting make the interface less obvious? Next, let's learn more about it with the editor.

After the bottom surface is treated, the entire panel is polished without 2000 sandpaper, and the rust and stains on the paint film are removed. Then, a degreasing agent is used as a complete cleaning wax. Then, when using 2000 sandpaper for grinding, the grinding area should be based on a primer spraying scale of approximately 10 centimeters.

Spray the scenery color, the scenery color should be slightly thinner than normal, and the spraying scenery color should be as small as possible& Quot; Clear paint spraying: The clear paint can be unfolded normally without too much air pressure. The clear paint should not be sprayed too far to the base color, leaving about 8 centimeters of sandpaper marks. Why not spray too far in one go? Because it needs to be connected, then add 1:1 to the interface water, interface water, and clear paint inside the paint.

Then spray varnish on the interface water in the other 8cm scale. The air pressure should be slightly reduced. Do not spray spray. Do not spray 8cm scale. Then use 100% interface water as the final connection. Why use 100% interface water? Because there is excessive paint fog outside, spray the interface water on the surrounding paint fog twice. When drying, you will find that the fog will follow the evaporation of the interface water.

When polishing, all you need to do is polish the area on the paint, the gray spots, and the area where the interface water is connected, and you can ignore the entire polishing process directly. As long as you can understand what I'm saying, the interface will not be obvious after polishing. Even if you don't tell him it's a paint repair, you won't be able to see it.

Article source: Qingyuan Automotive Repair Paint http://www.jinliangxincai.com